For parking


We have a top of market-share of this industry in Japan.
We have constructed good reliance between our customers by providing high effectiveness, functionality products.

Each part is designed with Installation
Only needs flat pit to installation, and normally 1 day to be completed for installation

Although it depends on the environment where be set , our turntable maintains its capability more than 10 years with periodic maintenance.

Instruction for installation

1st step
Draw the center position in the flat pit with black ink.

2nd step
a. Set basement at predefined position in the pit
b. Adjust the level of SW Type Special Wheel and Center axis

3rd step
a. Set top of table
b. Adjust the drive unit position

4th step
Set corner framework

5th step
Place concrete around corner frame.

*This step isn’t included our service but build company matter.

Standard product for parking lot
Custom made is available

Type Turntable diameter
Movable load
Standard Product
Measurement in height
Rotation speed
Power source
ISB-40 4000 2500 450 1 0.75 3P/AC200V
ISB-45 4500 2500 500 1 0.75
ISB-55 5500 8500 600 1 1.5 × 2

Principal mechanism

Each basement is independent.
We can adjust the level by bolt part.
SW wheel and center axisWheels which is located in periphery and Center axis
Wheels are own product “SW Type Special Wheel” and also Center axis is own produced.
They hold up top of table and provide good rotation degree.
Drive unitDrive unit
It consists of 3 parts, roller, reduction gear, and motor.
Top of tableTop of table
It is own produced with our precious plate working technology.
Corner frameCorner frame
It works as a formwork and is set being kept constant clearance between principal.
Operating and control panelOperating and control panel
There are 2 buttons, right and left, on the panel. Put the button to activate and Release the button to stop. Turntable keeps rotating until release the button.
Installation type is independence type or wall-hanging type.


Ring as a position line to stoppingRing as a position line to stopping
It is helpful If it is impossible to keep usable dimension to rotate.
Zinc platingZinc plating in specific part
Zinc-treated checkered steel plate and corner frame is available. It is a good method in cost performance to prevent rust
Zinc-treatedZinc-treated in all parts
It is effective especially to prevent salt damage.
low-noise Specification for low-noise
Use MC Nylon in head of SW Type Special Wheel.
Stone pitchingStone pitching
For artistic design.
*finishing construction is not our service but building company matter.
Remote controlRemote control
Pay attention to safety surrounding area when it is used.
About Installation processAbout Installation process
As explained, basically setting corner frame is the final process, but as to case, it is possible to be set before principal installed.
It enables slow-start rotation thereby noise that occurs at first motion is reduced.
Measure in height
Change is available as to requirement.

Copyright © 2011 IGUCHI KIKO CO.,LTD. All rights reserved.